Command And Response Table For Sis Commands - Extron electronics MKP 2000 User Manual

Command and Response Table for SIS Commands

Command
Front panel security lockout (executive mode)
Panel locked mode
User mode
Administrator mode
View front panel lock status
X2^ = Executive mode
KEY:
Pass-through (RS-232 port redirect)
Configure redirect mode
Example:
The "L" or "D" delimiter in value X% is case sensitive and must be uppercase.
NOTE:
Disable redirect
View redirect
X@
= RS-232 port number
KEY:
X#
= n = –1 = redirect serial port data from the specified port to allow for a transparent pass through mode. The
response is returned with leading zeroes. n = the maximum number of serial ports that the IP link supports.
verified at this port.
X$
= Time (in 10 ms increments) to wait for receive data before releasing the port to another source (min = 1 [10 ms],
maximum = 32767 [32.767 seconds], default = 10 [100 ms]).
X%
= Numerical value (nnnn) to set L (length of message to receive) or assign as a D (delimiter). L = number of byte
count (min = 0, max = 32767, default = 0). D = decimal number for ASCII character (min = 0, maximum = 00255,
default = 00000L).
Information requests
Request part number
Request information
Query firmware version
Query verbose firmware
version
Response
description:
X^
KEY: = Firmware version
X&
= Verbose firmware version-description-upload date/time.
Reset
Names reset
Absolute reset
28 MKP 2000 • Remote Control
ASCII Command Response
(host to unit) (unit to host)
2x
Exe2
1x
Exe1
0x
Exe0
X2^
x
0 = Administrator mode (panel unlocked), 1 = User mode, 2 = Panel locked
E X@ X# X$ X%
}
* * * CD Cpn
E
}
1*2*50*10DCD Cpn01
00050,00000D
E X@
}
*0CD Cpn
00000,00000,00000L
E X@ X#
}
CD ,
1 = host, 2 = switcher.
N/n
60-682-00
I/i
MKP
X^
Q/q ]
0Q/q X& ]
Ethernet protocol firmware version - controller firmware version - updated
]
firmware version
Bootstrap version (x.xx)
E }
ZXXX Zpx
E
}
ZQQQ Zpq
]
]
]
]
X@ • X# X$ X%
]
Ccd , ,
•
Ccd00002,
]
X@ •
Ccd
]
X$ X%
]
,
]
• ]
2000
]
]
Additional Description
Lock front panel.
Enable only input and output
selection from the front panel.
Unlock front panel.
Turn redirect mode on and specify
port parameters.
Redirect port 1 to port 2. Wait 500
ms for response.
View redirect mode on and off
status.
X%
is
Report model name.
Firmware build with 2 decimals
(x.xx).
Erase all presets, preset names,
input names, and output names.
Perform a Names reset plus
restoring all IP settings.