Performing A Hard Reset - Extron electronics MKP 2000 User Manual

2.

Performing a Hard Reset

The hard reset function restores the MKP to its original factory default firmware configuration
and erases all user-installed software or firmware.
Follow these steps to perform a hard reset:
ATTENTION:
NOTE: The hard reset does not change the IP address, the subnet mask, the gateway
1.
2.
22 MKP 2000 • Operation
Press and hold
the Reset button.
3
Events
seconds
R
(Mode 3)
Reset
Press and hold
the Reset button.
6
IP System
seconds
R
(Mode 4)
Reset
Press and hold
the Reset button.
9
Absolute seconds
R
(mode 5)
Reset
Figure 24. Performing Soft Resets
Release the button and then immediately press and release the
Reset
again. Nothing happens if the second momentary press does not occur within
1 second.
Ensure that you have backed up any locally-created HTML, JavaScript,
or other files that have been uploaded to the MKP user file space before you perform
the hard reset. A hard reset will erase all locally-created files from the MKP.
address, or the matrix switcher IP address.
Turn off power to the switcher.
Press and the
Hold Reset
MKP (see figure 25).
Press and hold the
Reset button while you
apply power to the MKP.
R
The LED flashes
on and off.
R
Release the Reset button.
Figure 25. Performing a Hard Reset
R
LED flashes
Release, then
once.
immediately
press and
R
release again.
R
LED flashes
Release, then
twice.
immediately
press and
R
release again.
R
LED flashes
Release, then
three times.
immediately
press and
R
release again.
button on the rear panel while you apply AC power to the
Power
button
Reset