Symbol Definitions - Extron electronics MKP 2000 User Manual

Symbol Definitions

]
or
|
• = Space character
W or E = W or Escape key can be used interchangeably.
X!
X@
X#
pass
number of
X$
source
X%
(delimiter).
00000L
NOTE: The numeric value directly precedes the identifier; for example:
X^
X&
X*
X(
NOTE: The default X( value is
X1)
X1!
28800
X1@
X1#
26 MKP 2000 • Remote Control
= Carriage return with line feed
}
= Pipe character or carriage return (no line feed) can be used interchangeably.
= On/off status
= off/disable
0
= on/enable
1
= RS-232 port number
= host
1
= switcher
2
= = = redirect serial port data from the specified port to allow for a transparent
n – 1
through mode. The response is returned with leading zeroes.
serial ports that the IP link supports.
= Time (in ms increments) to wait for receive data before releasing the port to another
10
(min = [ ms], maximum =
1 10
= Numerical value (nnnn) to set L (length of message to receive) or assign as a D
L = number of byte count (min =
D = decimal number for ASCII character (min =
).
3-byte length or X% = "
10D
sensitive and must be uppercase.
= Firmware version = Bootstrap version (
= Verbose firmware version-description-upload date/time.
= Voltage = ( V), Voltage
1 3.3
= Verbose/response mode
= clear/none assigned (default)
0
= verbose mode
1
= tagged responses for queries
2
= 1 and 2 (verbose and tagged)
3
If tagged responses are enabled, all read commands return the constant string plus the data,
the same as setting the value. For example, the MKP responds Ipn•
command.
= Security level
= clear/none
0
= user password assigned
11
= administrator password assigned
12
= Baud rate , ,
300 600
,
, , or
38400 57600 115200
= Parity (1st character only) = Odd, Even, None (default), Mark, Space
= # of data bits = 7 or 8 (default)
X% is verified at this port.
[ seconds], default =
32767 32.767
, max = , default =
0 32767
, maximum =
0
" to specify an ASCII delimiter of
)
x.xx
( V), Temperature (degrees Fahrenheit) (
2 12.0
for Telnet and for RS-232.
0 0
, , , ,
1200 1800 2400 3600 4800
= the maximum
n
[ ms]).
10 100
).
0
, default =
00255
X% = " " to specify a
3L
. The identifier, "L" or "D" is case
0A
)
xxx.xx
]
X1^ to the E
, (default), ,
9600 14400 19200
}
•CN
,