Control Panel Security Lockout (Executive Mode); Rear Panel Resets; Performing Soft Resets - Extron electronics MKP 2000 User Manual

Control Panel Security Lockout (Executive Mode)

The MKP 2000 provides the following three levels of front panel security lockout (executive
modes):
•
•
•
To step through the selections for the three executive modes:
1.
2.
Simultaneously press
and hold these buttons.
BACK
Figure 23.

Rear Panel Resets

Performing Soft Resets

The remote control panel has three soft resets available that restore various tiers of MKP
settings to their defaults.
•
•
•
To perform a soft reset of the MKP 2000:
1.
Panel Locked mode — All front panel controls are locked. Selections and setup
cannot be performed from the front panel.
User mode — Front panel operation is limited to input and output selection. The panel
configuration, IP, and switcher addressing functions are locked.
Administrator mode (default) — All front panel controls are available.
Press and hold the , ,
1 3 Back
one of the following messages, indicating the executive mode that has been set
(approximately 3 seconds).
Administrator mode — The LED display flashes
•
" ".
...
User mode — The LED display flashes
•
Panel Locked mode — The LED display shows
•
Repeat step 1 until the LED indicates the mode you want.
1 3
3
seconds
LOC
CANCEL
Control Panel Lockout: Switching to Administrator Mode
Events (mode 3) reset — Restarts the communications and control events.
IP system (mode 4) reset — Resets most IP protocols to their default settings.
NOTE: IP system reset clears the Internet protocol (IP) settings, but does not reset
the target address, the host control setting, the priority setting, or any user-loaded
files.
Absolute (mode 5) reset — Performs all of the system reset functions and clears the
MKP IP address to
192.168.254.253
is identical to the E
ZQQQ
Press and hold the
Reset
reset), twice (for IP system reset), or three times (for absolute reset) (see
the next page).
, and buttons until the LED window displays
Cancel
, then
LOC
The LED display flashes the
LOC, then Ad messages.
Ad
and subnet mask to
]
SIS command (see Reset
( ) button until the LED blinks off once (for events
R Reset
, then ; then displays
LOC Ad
; then displays " ".
Us ...
.
LOC
The ". . ." message
remains for
approximately 10
seconds
. . .
. This function
255.255.0.0
on page 28).
figure 24
MKP 2000 • Operation
on
21