Remove The Battery - Welch Allyn Connex Spot Monitor Service Manual

52 Disassembly and repair

Remove the battery

Before removing the battery, power down the monitor as described in this manual.
1. Place the unit face down on the table as shown.
2. Loosen the captive Phillips screw to remove the battery door.
3. Disconnect and remove the battery.
Reassembly notes
Kit item:
• 105973, Battery pack
Note Reassembly is the reverse of disassembly.
WARNING Defective batteries can damage the monitor. If the battery
shows any signs of damage or cracking, it must be replaced immediately
and only with a battery approved by Welch Allyn.
®
Connex Spot Monitor