Welch Allyn Connex Spot Monitor Service Manual page 35

Service manual
DHCP
4. Touch Test network connection.
The status of the server connections appears.
5. Touch OK.
6. Do one of the following:
•
•
Specify Bluetooth settings
This task is applicable only to monitors that have a Bluetooth radio installed. Devices can
be configured with a wireless or a Bluetooth radio. A configuration must be loaded to
view regulatory information.
1. In Advanced settings, touch the Network > Bluetooth® tabs.
2. Specify settings.
Setting
Allow Bluetooth configuration
Device name
Regulatory
3. Do one of the following:
•
•
Specify device IP settings
A radio card must be installed and operational to specify the device IP settings.
1. In Advanced settings, touch the Network > Device IP tabs.
2. Specify settings.
Setting
Ethernet
IP address
Subnet mask
Gateway
To continue in Advanced settings, touch another tab.
To exit Advanced settings and return to the Home tab, touch Exit.
To continue in Advanced settings, touch another tab.
To exit Advanced settings and return to the Home tab, touch Exit.
Note The DNS option is only available in the following
conditions:
• The version of the installed radio is 3.00.02 or greater
• The radio is disabled
• No radio is installed
Enable the device to connect to a Network Rendezvous
Service (NRS) by entering a port number and then
connecting at a provided IP address. In the NRS Port
entry field, enter the port number. The range of entry is 0
to 65535. After successfully connecting to the server, the
NRS IP addresses and the Vendor class identifier appear
onscreen.
Action/Description
Enable the device to connect to a host or other server
with the Bluetooth radio.
Enter the 8-character device name.
Displays the WiFi regulatory certification information.
Action/Description
Use DHCP Static ID
Select or
If Static ID is selected, specify these settings.
Advanced settings 29
.