Welch Allyn Connex Spot Monitor Service Manual page 67

Service manual
Reassembly notes
SpO2 insert options are Masimo, Nellcor, Nonin, or none.
Kit items:
• 105926, Masimo insert only
• 105927, Nellcor insert only
• 105929, Nonin insert only
• 105928, No SpO2 insert only
Note
When replacing the SpO2 insert
1. First complete the following steps:
• Attach the power harness to the SpO2 insert. (See "Attach the power harness to the
insert.")
• Install any new SpO2 board, if applicable. (See the reassembly notes in "Remove the
SpO2 board." )
Attach the power harness to the insert
Align the power harness with the insert and secure it with 2 T-10 Torx screws (see
the Torque Value Table).
Reassembly is not the reverse of disassembly, but it is the same for each
insert.
Disassembly and repair 61