Welch Allyn Connex Spot Monitor Service Manual page 197

Service manual
Message
Radio not functional.
35001e
Radio not functional.
35001f
Radio not functional.
350020
Radio not functional.
350021
Radio not functional.
350025
Radio not functional.
350027
Radio not functional.
350028
Radio not functional.
350029
Invalid radio
configuration.
Reconfigure and try
again. 35002a
Radio not functional.
35002b
Radio not functional.
35002c
Possible cause
MAC request failed. There is an
internal software error on the
radio indicating a Linux kernel
error or a failure to initialize the
network interface
Invalid power mode. There is an
internal software error on the
radio
Post results missing. There is an
internal software error on the
radio
Post results format. There is an
internal software error on the
radio
Unrecognized component. There is
a version compatibility error if the
radio or the monitor adds new
features and software upgrade of
the radio fails after the monitor
successfully updates
Missing release file. There is an
internal software error on the
radio with a missing file
Not ready. Displays when logging
verbosity is turned on
Disconnected. There is a software
communication issue between the
host and the radio. Socket
connection is down
Invalid parameter. There is a
software issue on the monitor
while trying to configure radio
Timeout. There is a software
communication issue between the
host and the radio
The device cannot communicate
with the radio through the internal
radio IP address
Suggested action
Check for a software update and apply it.
If still present, replace the radio.
Check for a software update and apply it.
If still present, replace the radio.
Check for a software update and apply it.
If still present, replace the radio.
Check for a software update and apply it.
If still present, replace the radio.
Check for a software update and apply it.
If still present, replace the radio.
Check for a software update and apply it.
If still present, replace the radio.
Check for a software update and apply it.
If still present, replace the radio.
Check for a software update and apply it.
If still present, replace the radio.
Check the radio configuration. If the
problem is still present, reset the radio to
factory defaults. If the problem persists,
check for software update and apply it. If
still present, replace the radio.
Check for a software update and apply it.
If still present, replace the radio.
Navigate to Advanced Settings >
Service > Radio Status. Approximately
3-4 minutes after the error code appears,
a Mac Address text field appears on this
tab. Communicate with Welch Allyn for
assistance in entering the correct Mac
address.
If still present, replace the radio card.
Appendix 191
Alarm
priority
Very low
Very low
Very low
Very low
Very low
Very low
Very low
Very low
Very low
Very low
Very low