Xerox AltaLink B80 series User Manual page 28

Getting Started
P P a a p p e e r r T T r r a a y y O O p p t t i i o o n n s s
Configuring Dedicated Paper Trays
The system administrator can set trays to Fully Adjustable mode or Dedicated mode. When a paper
tray is set to Fully Adjustable mode, you can change paper settings each time that you load the tray.
When a paper tray is set to Dedicated mode, the control panel prompts you to load a specific paper
size, type, and color.
Your printer can have three high-capacity paper trays installed, depending on configuration. High-
capacity trays are configured as Dedicated trays. Each high-capacity tray can feed A4 (210 x 297
mm) or Letter (8.5 x 11 in.) paper as standard. Tray 6 can feed more paper sizes if the optional kits
are installed. High-capacity trays are designed to hold larger amounts of paper for fewer printing
interruptions.
Note: To configure tray settings, refer to the System Administrator Guide at
support/ALB80XXdocs.
Configuring Trays 3 and 4
Trays 3 and 4 in the Tandem Tray Module are high-capacity paper trays that can hold A4-size (210 x
297 mm) or Letter-size (8.5 x 11 in.) paper. You can adjust these trays to hold either of these paper
sizes.
To configure Trays 3 and 4 in the Tandem Tray Module:
Note: Access to the rear paper guide in Tray 3 is limited. If you require assistance to adjust the
paper trays, contact your local Xerox representative.
1. To access the rear paper guides in Trays 3 and 4, remove Tray 2 from the printer.
2. Pull out Tray 3 or 4 and remove any paper from the tray.
3. To adjust the front paper guide, slide forward the green clips, then lift the front paper guide
gently to release it from the tray. Move the guide to the new paper-size position. Align the tabs at
the top and bottom of the guide with the corresponding slots on the tray, then slide back the
green clips.
28 Xerox ® AltaLink
User Guide
® B80XX Series Multifunction Printer
www.xerox.com/