Xerox AltaLink B80 series User Manual page 278

Regulatory Information
ENERGY STAR
The ENERGY STAR program is a voluntary scheme to promote the development
and purchase of energy efficient models, which help to reduce environmental
impact. Details on the ENERGY STAR program and models qualified to ENERGY
STAR can be found at the following website: www.energystar.gov.
The ENERGY STAR and ENERGY STAR mark are registered United States
trademarks.
The ENERGY STAR Imaging Equipment Program is a team effort between
United States, European Union, and Japanese governments and the office
equipment industry to promote energy-efficient copiers, printers, fax,
multifunction printers, personal computers, and monitors. Reducing product
energy consumption helps combat smog, acid rain, and long-term changes to
the climate by decreasing the emissions that result from generating electricity.
Power Consumption and Activation Time
The amount of electricity that a device consumes depends on the way the device is used. This device
is designed and configured to enable you to reduce your electricity usage.
Power Saver modes are enabled on your device to reduce energy consumption. After the last print,
the device transitions to Ready mode. In this mode, the device can print again immediately. If the
device is not used for a specified period, the device transitions to Low Power mode, then to Sleep
mode. In these modes, to enable reduced-power consumption, only essential functions remain active.
The device takes longer to produce the first print after it exits the Power Saver modes than it takes to
print in Ready mode. This delay is the result of the system waking up and is typical of most imaging
devices on the market.
To save power, you can enable Auto Power Off mode on your device.
To change the Power Saver settings, refer to the User Guide at www.xerox.com/support/ALB80XXdocs.
For further assistance, contact your System Administrator or refer to the System Administrator Guide.
To enable Auto Power Off mode, contact your System Administrator. For details, refer to the System
Administrator Guide at www.xerox.com/support/ALB80XXdocs.
To learn more about Xerox participation in sustainability initiatives, go to:
xerox/environment/enus.html.
Note: Changing the default Power Saver activation times can result in an overall higher energy
consumption of the device. Before you turn off Power Saver modes or set a long activation
time, consider the increase in device power consumption.
Default Power Saver Settings
This device is ENERGY STAR
Equipment. The transition time from Ready mode to Sleep mode can be set up to 30 minutes. The
default value is 1 minute. The total transition time from Ready mode to Sleep mode can take up to
30 minutes.
To change the Power Saver settings, contact your System Administrator, or refer to the System
Administrator Guide at www.xerox.com/support/ALB80XXdocs.
278 Xerox ® AltaLink
User Guide
® -qualified under the ENERGY STAR Program Requirements for Imaging
® B80XX Series Multifunction Printer
www.xerox.com/about-