Xerox AltaLink B80 series User Manual page 173

4. To engage the fine-adjustment block, release the guide lock, then slide in the length or width
paper guide. The paper guides move in increments of 1mm (0.04 in.).
5. Adjust the length and width paper guides until they touch the edges of the paper.
L L o o a a d d i i n n g g P P a a p p e e r r i i n n T T r r a a y y s s 3 3 a a n n d d 4 4
Trays 3 and 4 are high-capacity paper trays. They are set as dedicated trays and hold A4-size (210 x
297 mm) or Letter-size (8.5 x 11 in.) paper only. Tray 3 holds 1600 sheets of paper. Tray 4 holds 2000
sheets of paper.
The control panel displays a warning message when the paper in the tray is in short supply, or when a
tray is empty.To change the paper size, refer to
To load paper in Trays 3 and 4:
1. Pull out Tray 3 or Tray 4 until it stops. Wait for the tray to lower and stop.
2. The control panel displays the paper tray settings. Ensure that you load the correct paper type.
Note: Do not load custom-size paper into Trays 3 or 4.
3. Fan the edges of the paper before loading it into the paper trays. This procedure separates any
sheets of paper that are stuck together and reduces the possibility of paper jams.
Note: To avoid paper jams and misfeeds, do not remove paper from its packaging until
necessary.
Configuring Trays 3 and
Xerox ® AltaLink ® B80XX Series Multifunction Printer
Paper and Media
4.
User Guide
173