Xerox AltaLink B80 series User Manual page 227

Probable Causes
A network configuration problem exists.
The printer is connected to an outlet with a voltage
or frequency that does not match the printer
specifications.
P P r r i i n n t t e e r r D D o o e e s s N N o o t t P P r r i i n n t t
Probable Causes
The printer is in Power Saver mode.
The printer has an error.
The printer is out of paper.
A toner cartridge is empty.
The print cartridge has reached end of life.
No control panel indicators are lighted.
The printer is busy.
The printer cable is disconnected.
Solutions
Unplug the network cable. If the problem is not
resolved, contact your system administrator to
reconfigure your network installation.
Use a power source with the specifications listed in
Electrical Specifications.
Solutions
On the control panel, press the Power/Wake button.
If the Status LED is blinking amber, follow the
instructions on the control panel to clear the error. If
the error persists, contact your Xerox representative.
Load paper into the tray.
Replace the empty toner cartridge.
Replace the print cartridge.
Power off the printer, confirm that the power cord is
plugged in correctly to the printer and the outlet,
then power on the printer. If the error persists,
contact your Xerox representative.
• If the Status LED is flashing blue, a previous print
job could be the problem.
1 At your computer, use the printer properties to
delete all print jobs in the print queue.
2 At the control panel, touch Jobs, then delete
all pending print jobs.
• Load the paper in the tray.
• If the Status LED does not flash once after you
send a print job, check the connection between
the printer and the computer. Power off the
printer, then power on.
If the Status LED does not flash once after you send
a print job, check the connection between the printer
and the computer.
Xerox ® AltaLink ® B80XX Series Multifunction Printer
Troubleshooting
227
User Guide