Xerox AltaLink B80 series User Manual page 241

P P a a p p e e r r M M i i s s f f e e e e d d s s
Probable Causes
The paper is not correctly positioned in
the tray.
The paper tray is too full.
The paper guides are not correctly
adjusted to the paper size.
The tray contains warped or wrinkled
paper.
The paper is moist from humidity.
Using paper of the wrong size,
thickness, or type.
The feed rollers are dirty.
L L a a b b e e l l a a n n d d E E n n v v e e l l o o p p e e M M i i s s f f e e e e d d s s
Probable Causes
The label sheet is facing the wrong way in the tray.
Labels are missing, curled, or pulled away from the
backing sheet.
Solutions
• Remove the misfed paper and reposition it properly in the tray.
• Adjust the paper guides in the tray to match the size of the
paper.
Remove some of the paper. Do not load paper past the fill line.
Adjust the paper guides in the tray to match the size of the paper.
Remove the paper, smooth it out, and reload it. If it still misfeeds,
do not use that paper.
Remove the moist paper and replace it with new, dry paper.
Use only Xerox approved paper. For more information, refer to
Supported Paper.
With a clean, lint-free cloth moistened with water, wipe the feed
rollers until they are clean. For more information, refer to
the Printer.
Solutions
• Load label sheets according to the instructions
from the manufacturer.
• Load labels in the correct orientation for the tray.
For information about loading and using labels, refer
to Labels.
Do not use any sheet where labels are missing,
curled, or pulled away from the backing sheet.
Xerox ® AltaLink ® B80XX Series Multifunction Printer
Troubleshooting
Cleaning
241
User Guide