5) Plug in the serial RS main S cable [1] to the connectors on the host ma-
chine.
- 2 connectors [2]
[2]
F-2-179
When attaching the blanking sheet, make sure the sheet does not run off the edge of the coin vender I/F PCB unit. When this happens, the sheet may come off because
it touches the coin vender I/F BOX cover that is mounted in step 11).
F-2-181
2-50
[1]
[1]
[B]
[A]
[1]
6) Pull out the serial RS main S cable [2] through the cut-off [1] and then at-
tach the rear right cover [3].
- 4 screws [4] (the screws removed in step 3))
F-2-180
7) Close the cassette upper right cover and cassette lower right cover.
8) Peel off the released paper on the blanking sheet [1], attach it along the
mark-off line [A] and end face [B] of the coin vender I/F PCB unit.
9) Pull out the serial RS main S cable [2] through the hole [1] on the plate,