Switching Off The Product; Turning Bluetooth On The Prosthesis On/Off; Switching Bluetooth Off/On Using The Cockpit App - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

The following parameters can be modified in MyModes:
Parameter
Gain
Volume

9.3 Switching off the product

CAUTION
Using the product while switched off
Falling due to unexpected behaviour of the product because of changed damping behaviour.
► Before using the product, switch it on by connecting the power supply and battery charger.
In certain cases, e.g. for storage or transportation, the prosthesis can be purposely switched off. It can only be
switched on by connecting to a live outlet, a power supply and a battery charger.
Switching off
The product can be switched off by briefly connecting/disconnecting the battery charger 3 times.
1) Connect the battery charger to the product and wait for the beep signal.
2) Disconnect the charging plug immediately after the beep signal sounds.
3) Immediately after another beep signal sounds, reconnect the charging plug.
4) Carry out this process (steps 2 and 3) a total of three times.
→ After the charging plug has been disconnected for the third time, a descending sequence of 5 beeps is emitted
and the product is then switched off.
INFORMATION
After waiting too long between connecting/disconnecting (e.g. until a vibration signal is emitted), the process of
connecting/disconnecting 3 times has to be repeated.
Switching on
1) Connect the power supply with battery charger to the socket.
2) Connect the battery charger to the product.
→ The correct connection of the battery charger to the product is indicated by feedback (see Page 42 and see
Page 44).

9.4 Turning Bluetooth on the prosthesis on/off

INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (function only available in
basic mode) or by connecting/disconnecting the battery charger. Bluetooth is then turned on for approx. 2
minutes. During this time, the app must be started and used to establish a connection. If required, Bluetooth on
the prosthesis can be switched on permanently afterwards (see Page 33).

9.4.1 Switching Bluetooth off/on using the cockpit app

Switching off Bluetooth
1) When the component is connected, tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Functions".
3) Tap the entry "Deactivate Bluetooth".
4) Follow the on-screen instructions.
C-Leg 3C98-3/3C88-3
Adjustment soft­ Setting range,
ware range app
0 to 100 +/- 10
0–4 0–4
Meaning
Value for speed at which flexion resistance
increases as the knee angle increases
Volume of beep signal for confirmation tones
(e.g. when checking the charge level, switch­
ing MyModes). The "0" setting deactivates
the audible feedback signals. However,
warning signals are still generated if errors
occur.
Use
33