Tool Jog Operation - Mitsubishi Electric RV-4FM-SE Series Instruction Manual

(3) TOOL jog operation

Select TOOL jog mode
<CURRENT> JOINT
J1: +0.00
J2: +0.00
J3: +90.00
J4: +0.00
TOOL JOG
XYZ
Set jog speed
<CURRENT> JOINT
J1: +0.00
J2: +0.00
J3: +90.00
J4: +0.00
TOOL JOG
XYZ
Moving along the tool coordinate system
* The direction of the flange will not change
・When the [+X (J1)] keys are pressed, the robot will move along the X axis plus direction of the tool coordinate
system.
When the [-X (J1)] keys are pressed, move along the minus direction.
・When the [+Y (J2)] keys are pressed, the robot will move along the Y axis plus direction of the tool coordinate
system.
When the [-Y (J2)] keys are pressed, move along the minus direction.
・When the [+Z (J3)] keys are pressed, the robot will move along the Z axis plus direction of the tool coordinate
system.
When the [-Z (J3)] keys are pressed, move along the minus direction.
◇◆◇ When the robot is in the transportation posture ◇◆◇
There are directions from which linear movement is not possible from the transportation posture. In this case, the
robot will not move. Refer to section
linear movement is possible, and then carry out XYZ jog.
100% M1 T0
J5: +0.00
J6: +0.00
:
:
3-XYZ CYLNDR
⇒
TOOL jog mode
100% M1 T0
J5: +0.00
J6: +0.00
:
:
3-XYZ CYLNDR
⇒
Setting the speed
Control
＋Z
point
制御点
Page 29, "(1) JOINT jog
[JOG] Press the key and display the jog screen.
("JOG" is displayed on the screen bottom)
Check that the "TOOL" in jog mode is displayed
on the screen.
If other jog modes are displayed, please press the
～
function key corresponding to the "TOOL." (If
the jog mode which he wishes under the screen is
not displayed, it is displayed that the [FUNC -
TION] key is pressed)
If it finishes jog operation, press the [JOG] key
again, or function key which correspond to
"close."
Whenever it presses the key of [OVRD ↑ ], the
override goes up. Conversely, if the [OVRD ↓ ]
key is pressed, it will go down.
The current setting speed is displayed on screen
upper right, and "STATUS NUMBER" of the
controller.
Set the override to 10% here for confirmation
work.
＋Y
＋X
operation"", and move the robot to a position where
2 Unpacking to Installation
Confirming the operation 2-33