Replacing The Battery (Robot Arm) - Mitsubishi Electric RV-4FM-SE Series Instruction Manual

5 Maintenance and Inspection

(1) Replacing the battery (robot arm)

CAUTION
CAUTION
The battery installation position is shown in
following procedures.
CONBOX cover
Battery holder
Battery
Fig.5-17 ： Replacing the battery
1) Turn the controller control power OFF.
2) Remove CONBOX cover <1>, referring to
3) Replaces the backup battery one by one. The battery holder is located inside the CONBOX cover <1>.
Remove the old battery from the holder, and disconnect the lead connector.
4) Insert the new battery into the holder, and connect the lead connector. Replace all batteries with new ones
at the same time.
5) All the batteries should be checked that it has been exchanged newly. If the old battery is contained, gener -
ating heat and damaging may occur.
6) Install the CONBOX cover <1> as before. Be careful so that the cable may not be inserted.
7) Initialize the battery consumption time.
Always carry out this step after replacing the battery, and initialize the battery usage time. Refer to the
separate "Instruction Manual/Detailed Explanation of Functions and Operations" for details on the opera -
tion methods.
[Caution] If the old battery is replaced because it has been used up, it is necessary to set the origin again.
Refer to
Maintenance and inspection procedures
5-100
The power supply for the encoder is supplied by cable connected with battery board.
The cable must be connected while replacing the battery or operating usually. Thus, if
the cable connection is incomplete, the encoder position data will be lost, and reset -
ting the origin is necessary.
Replace the battery one by one . If all batterys are removed the encoder data will be
lost, and resetting the origin is necessary.
SE1101/1501/1502: Hexagon flange bolt (4 pc.)
SE1102: Hexagon socket head cap screw (4 pc.)
Page 104, "5.6 Resetting the origin"
Fig. 5-17. Refers to the figure and replaces the batteries in the
Lead connector
Page 82, "5.3.2 Installing/removing the
and reset the origin using the ABS origin method.
Note) Although the figure is the
example of RV-4F other
types are the same also.
cover".