Tool Measurement With Tt - HEIDENHAIN iTNC 530 HSCI Technical Manual

4.4.10 Tool measurement with TT

MP Function and input
MP6500 Tool measurement with TT 130
Format:
Input:
0: Disabled
1: Not disabled
Bit 1 –
0: Tool radius measurement allowed. Tool length
1: Tool radius measurement and individual tooth
Bit 2 –
0: Tool length measurement with stationary spindle (bit
1: Tool length measurement with rotating spindle, only if a
Bit 3 –
0: Tool measurement with spindle orientation
1: Tool measurement without spindle orientation. Individual
Bit 4 –
0: Automatically determine speed
1: Always use minimum spindle speed
Bit 5 – NC stop during tool checking
0: The NC program is not stopped when the breakage
1: If the breakage tolerance is exceeded, the NC program is
Bit 6 – NC stop during tool measurement
0: The NC program is not stopped when the breakage
1: If the breakage tolerance is exceeded, the NC program is
July 2013
%xxxxxxxxxxxxxxx
Bit 0 – Cycles for tool measurement
measurement with rotating spindle
measurement disabled
1=1)
tool radius offset (TT: R-OFFS) has been entered
in the tool table
tooth measurement not possible. Tool radius
measurement possibly faulty
tolerance is exceeded
stopped and the error message Tool broken is
displayed
tolerance is exceeded
stopped and the error message Touch point
inaccessible is displayed
4.4 List of machine parameters
Software Page
version and
behavior
PLC 1552,
1553,
RUN
1555,
1557,
1559,
1559
537