“Tilt Working Plane” (Inactive Preset Table) - HEIDENHAIN iTNC 530 HSCI Technical Manual

July 2013
MP7500 "Tilt working plane" (inactive preset table)
Format: %xxxxxxxx
Input: Bit 0 – Switch-on "tilted working plane" function
0: Off
1: On
Bit 1 –
0: Angles correspond to the position of the tilting axes of the
head/table
1: Angles correspond to the spatial angle (the iTNC calculates
the position of the tilted axes of the head/table)
Bit 2 –
0: The tilting axes are not positioned with Cycle 19
1: The tilting axes are positioned with Cycle 19
Bit 3 –
0: The current tilting-axis position is taken into account with
respect to the machine datum
1: The 0° position is assumed for the first rotary axis
Bit 4 –
0: Compensate mechanical offset during exchange of the
spindle head when calling M128, M114, TCPM or "tilted
working plane"
1: Compensate mechanical offset during PLC datum shift
Bit 5 –
0: The current tilting-axis position is taken into account with
respect to the machine datum
1: The tilting-axis position that was entered with the 3-D ROT
soft key applies
Bit 6 –
0: Spatial angle C is realized through a rotation of the coordinate
system
1: Spatial angle C is realized through a rotation of the table
Bit 7 –
0: The current tilting-axis position is taken into account with
respect to the machine datum
1: The active tilting-axis position is
a) derived from the tilting angles in the 3D ROT window if
manual tilting is active
b) derived from the reference coordinates of the rotary axes if
tilting is inactive
Bit 8 –
0: The tilting axis positioning is considered depending on bit 3,
bit 5 and bit 7
1: If manual tilting is active, the datum to be set for the principal
axes X, Y and Z is recalculated back to the home position of the
tilting element
6.5 Tilting and swivel axes
767