Selecting The Traverse Range - HEIDENHAIN iTNC 530 HSCI Technical Manual

Selecting the
traverse range
624
You can switch the range of traverse in two ways:
Select the traverse range with Module 9151 or 9152. With Module 9152 you

can change the axis display at the same time.
or
Select the traverse range with M4574 and M4575 according to the table

below.
In all operating modes you must activate the traverse range with strobe

marker M4135.
You may only use the traverse range switching function via M4574 and M4575
during an M/S/T/Q strobe in all operating modes (except for Manual Operation
and El. Handwheel).
M4574 M4575 Traverse range/Datum
0 0 Range 1
1 0 Range 2
0 1 Range 3
If the axis traverse limits are changed by the user (after pressing the MOD
key), marker M4624 is set. The marker must then be reset by the PLC
program.
M4574 Select the traverse range (with
M4575)
M4575 Select the traverse range (with
M4574)
M4135 Strobe marker for selecting the
traverse range
M4624 Strobe marker for selecting the
traverse range
HEIDENHAIN Technical Manual iTNC 530 HSCI
Set Reset
PLC PLC
PLC PLC
PLC NC
NC PLC