ABB i-bus KNX Product Manual page 78

®
ABB i-bus KNX
Commissioning
Function sequence after download
or KNX bus voltage recovery
Options:
This parameter defines if function Sequence is active or inactive after KNX bus voltage recovery.
After a Gateway supply voltage recovery, the parameterized brightness value in the
Gx Fault, page 64 is set. The function Sequence is subsequently undertaken with the option defined here.
inactive: Function Sequence is not activated after a download or after KNX voltage recovery.
active: Function Sequence is activated after a download or after KNX voltage recovery. The lighting
group is switched on with the brightness value after KNX voltage recovery and restarted after an ON
telegram.
last status: The function Sequence receives the operating state, which it had before download or KNX
voltage failure.
Status response of function sequence
of the lighting group
Options:
This parameter defines whether the status of the function Sequence of the group is sent on the KNX. For
this purpose, the communication object Activate Sequence/Status is enabled.
no: The state of the function Sequence is not actively sent on the KNX.
yes: via object "Activate Sequence/Status": The common communication object Activate Se-
quence/Status receives a telegram with the value 1 to activate function Sequence and simultaneously
sends the current status of the function Sequence actively on the KNX. It is possible to parameterize
when the status is sent on the KNX. The following parameters appear for this purpose:
76 2CDC 507 114 D0201 | DGN/S 1.16.1
inactive
active
last status
no
yes: via object "Activate Sequence/Status"
send object value
Options: after a change
after request
after a change or request
after a change: The status is sent after a change.
after request: The status is sent after a request.
after a change or request: The status is sent after a change or a request.
Parameter window –