ABB i-bus KNX Product Manual page 106

®
ABB i-bus KNX
Commissioning
No.
13
This communication object is enabled if in the
brightness value of the DALI output is set with the option yes: via object "Brightness value/status.
This communication object has the same functions and properties as the communication object Brightness value. The status is
additionally fed back. At different brightness values of the DALI devices you can parameterize whether the DGN/S indicates
the smallest, the highest or the average brightness value. The parameterization is undertaken in the
Status, page 42.
Telegram value:
Note
If several groups are assigned to the communication object Brightness value/status, the status address
should be set as the sending address. In a KNX group with several status messages, it is useful to allow just
a single group member to feedback the status.
14
This communication object is enabled if in the
brightness value of the DALI output is set with the option yes: via separate object "Status brightness value".
Telegram value:
This communication object reports the current brightness value of the DALI device. At different brightness values of the DALI
devices you can parameterize whether the DGN/S indicates the lowest, the highest or the average brightness value. The value
of the communication object updates itself during a scene dimming process or sequence.
It is possible to parameterize if the status is sent on after a change and/or after request.
104 2CDC 507 114 D0201 | DGN/S 1.16.1
Function
Brightness value/status
Parameter window -
0 = OFF, or minimum dimming threshold
...
255 = 100 %
Status brightness value
Parameter window -
0 = OFF
...
255 = 100 %, max. brightness value
Communication object name
DALI output
Status, page 42, the parameter Status response of
DALI output
Status, page 42, the parameter Status response of
Data type Flags
1 byte C, R, W, T
DPT 5.001
Parameter window -
1 byte C, R, T
DPT 5.001