ABB i-bus KNX Product Manual page 43

®
ABB i-bus KNX
Commissioning
Slave emergency criterion:
Send object value
Options: after a change
after request
after a change or request
after a change: The status is sent after a change.
after request: The status is sent after a request.
after a change or request: The status is sent after a change or a request.
On gateway voltage failure
Options: yes
no
no: A gateway voltage failure does not trigger slave emergency lighting.
yes: A gateway voltage failure triggers slave emergency lighting. The information concerning
slave emergency lighting is passed on by the DGN/S.
On detection emergency operation by
emergency converter
Options: yes
no
no: A detected emergency lighting event by the emergency lighting converter is interpreted as
a non-relevant slave emergency lighting event for the lighting still functioning.
yes: An emergency lighting event detected by the emergency lighting converter is interpreted
as a relevant slave emergency lighting event for the lighting still functioning. This information is
passed on as parameterized above. Using the following parameter, you can parametrize how
many reported emergency lighting events from the emergency lighting converters are decisive
in defining a relative emergency lighting event for the functional lighting.
Number of detected emergency events
must be greater or equal
Options: 1...64
If the number of detected emergency lighting events reaches the value set here, the infor-
mation is sent on the KNX.
On lamp or ballast failure
Options: yes
no
no: A lamp/ballast failure is not interpreted as a relevant slave emergency lighting event for the
still functional lighting.
yes: A lamp/ballast failure is interpreted as a relevant slave emergency lighting event for the
still functional lighting. This information is passed on as parameterized above. Using the follow-
ing parameter, you can parametrize how many failures (lamps/ballast failures) must be de-
tected to be decisive in defining a relative emergency lighting event for the functional lighting.
Number of detected failures must be
greater or equal
Options: 1...10...64
If the number of detected lamp/ballast failures reaches the value set here, the information is
sent on the KNX.
DGN/S 1.16.1 | 2CDC 507 114 D0201 41