ABB i-bus KNX Product Manual page 147

®
ABB i-bus KNX
Planning and Application
The parameterization is undertaken in the
ues are retained, the sequence is automatically activated after download. The function Sequence is in
standby and can be started at any time by an ON telegram (value 1) to the communication objects Switch
or Switch/status of the lighting group which are members of the sequence. Alternatively, the function Se-
quence can be started via the communication objects Activate function Sequence of the lighting groups
members.
The function Sequence is often repeated as parameterized in
is possible to repeat the sequence up to 255 times or to allow it to run endlessly. The function Sequence
can be interrupted at any time by an OFF telegram (value 0) to the communication object Switch of the re-
spective lighting group.
The function Sequence jumps with the respective transition time to the final scene and then goes to stand-
by. In this state, the function Sequence can be restarted by an ON telegram (value 1) at any time. If the
function Sequence is in standby mode, where it is not operating, it can be switched off with an OFF tele-
gram. The function Sequence operation remains in standby mode in this case.
If the DGN/S receives a telegram with the value 0 on the communication object Activate function Se-
quence for a lighting group, the function Sequence is terminated and the current brightness of the lighting
group is retained. This is independent of whether the function Sequence is operating or in standby mode.
A renewed activation is implemented by a telegram with the value 1 to the communication object Activate
function Sequence. The function Sequence is activated, the function Sequence is started simultaneously.
The response to a dimming, set brightness value and scene telegram during function Sequence can be
parameterized in the
function Sequence can be deactivated, so that the lighting group reacts as a "normal" lighting group and
can only be reactivated by a telegram with the value 1 to the communication object Activate function Se-
quence.
Whether the function Sequence for a lighting group is activated is displayed via the communication object
Activate sequence/status or displayed in bit 14 in the diagnostics byte.
The state of function Sequence after Gateway supply voltage recovery as well as after KNX voltage recov-
ery is parameterized in the
In the following table, the response to received telegrams with the parameterized function Sequence is
shown:
Parameter window - Gx
Parameter window - Gx Sequence, page 74. The telegram can be ignored or the
Parameter window - Gx
Sequence, page 74. If the default val-
Parameter window Sequence
Sequence, page 74.
DGN/S 1.16.1 | 2CDC 507 114 D0201 145
on page 87. It