ABB i-bus KNX Product Manual page 75

®
ABB i-bus KNX
Commissioning
Function slave after download
or KNX bus voltage recovery
Options:
This parameter defines if function Slave is active or inactive after KNX voltage recovery.
After a gateway supply voltage recovery, the parameterized brightness value in the
Gx Fault, page 64 is set. The function Slave is then undertaken with the option defined here.
inactive: The function Slave is not activated after a download or after KNX voltage recovery.
active: The function Slave is activated after a download or after KNX voltage recovery. The lighting
group is controlled with the next brightness value, which is received via the communication object
Brightness value of slave.
last status: The function Slave receives the operating state which it had before download or KNX volt-
age failure.
Status response of function slave
of the lighting group
Options:
This parameter defines whether the status of the function Slave of the lighting group is sent on the KNX.
For this purpose, the communication object Activate slave/status is enabled.
no: The state of the function Slave is not actively sent on the KNX.
yes: via object "Activate slave/status": The common communication object Activate slave/status re-
ceives a telegram with the value 1 to activate function Slave and simultaneously sends the current sta-
tus of the function Slave actively on the KNX. It is possible to parameterize when the status is sent on
the KNX. The following parameter appears:
inactive
active
last status
no
yes: via object "Activate slave/status"
send object value
Options: after a change
after request
after a change or request
after a change: The status is sent after a change.
after request: The status is sent after a request.
after a change or request: The status is sent after a change or a request.
Parameter window –
DGN/S 1.16.1 | 2CDC 507 114 D0201 73