ABB i-bus KNX Product Manual page 48

®
ABB i-bus KNX
Commissioning
Coded brightness status response
of a device
Options:
no: The status of the brightness status of a DALI device is not actively sent on the KNX.
yes: The coded communication object Status brightness value coded (no. 16) is enabled. Using this
coded 2 byte communication object (address plus status), the brightness value of an individual DALI
device is sent on the KNX.
For further information see:
With the option yes, a further parameter appears:
send object value
Options:
Enable communication objects:
"Fault DALI" 1 bit
Options:
Using this communication object, a fault of the DALI communication of the DALI output, i.e. a short-
circuit > 500 ms or a data collision, can be sent or read, e.g. for diagnostic purposes. Some fault
communication objects are available for a lamp/ballast fault.
46 2CDC 507 114 D0201 | DGN/S 1.16.1
yes
no
Communication object no.
after a change
after request
after a change or request
after a change: The status is sent after a change.
after request: The status is sent after a request.
after a change or request: The status is sent after a change or a request.
yes
no
no: The communication object Fault DALI is not enabled.
yes: The communication object Fault DALI is enabled. As soon as there is a DALI fault on the
output, it is indicated by a 1 in the communication object Fault ballast. A further parameter ap-
pears:
send object value
Options: after a change
after request
after a change or request
after a change: The status is sent after a change.
after request: The status is sent after a request.
after a change or request: The status is sent after a change or a request.
16, page 106.