ABB i-bus KNX Product Manual page 46

®
ABB i-bus KNX
Commissioning
Switch value for different
values in the output
Options:
This parameter defines the status to be sent if DALI devices with different states are present on the
output.
coded switch status response
of a device
Options:
no: The status of the switch status of a DALI device is not actively sent on the KNX.
yes: The coded communication object Status switch coded (no. 15) is enabled. Using this coded 2
byte communication object (address plus status), the switching state of an individual DALI device is
sent on the KNX.
For further information see:
With the option yes, a further parameter appears:
send object value
Options:
44 2CDC 507 114 D0201 | DGN/S 1.16.1
OFF
ON
OFF: The switch status is only sent as an ON (telegram with the value 1) if all DALI devices are
switched on.
ON: The switch status is sent as an ON (telegram with the value 1) if at least one DALI device
is switched on.
yes
no
Communication object no.
after a change
after request
after a change or request
after a change: The status is sent after a change.
after request: The status is sent after a request.
after a change or request: The status is sent after a change or a request.
15, page 105.