ABB i-bus KNX Product Manual page 47

®
ABB i-bus KNX
Commissioning
Status response of brightness value
of the DALI output
Options:
The parameter defines how the current status of the brightness value of the DALI output (the lighting) is
sent on the KNX.
no: The brightness value is not actively sent on the KNX.
yes: via object "Brightness value/status": The brightness value is sent on the KNX via the communica-
tion object Brightness value/status (no. 13).
yes: via separate obj. "Status brightness value": An additional Status brightness value (no. 14) com-
munication object for the status message is enabled.
Note
This status message relates to all connected devices of the DALI output.
It is possible to parameterize the response of the status messages should differing states occur with the
devices.
With a change of the parameterization or after a subsequent switching of the status object, the assign-
ment of the group's addresses already allocated to the communication object Brightness value are lost
and need to be reprogrammed.
With the options yes:... two further parameters appear:
no
yes: via object "Brightness value/status"
yes: via separate obj. "Status brightness value"
Send object value
Options: after a change
after request
after a change or request
after a change: The status is sent after a change.
after request: The status is sent after a request.
after a change or request: The status is sent after a change or a request.
Brightness value for different
values in the output
Options: average brightness of all lamps in the output
highest brightness of all lamps in the output
lowest brightness of all lamps on the output
This parameter defines the status to be sent if devices with different states are present on the out-
put.
average brightness of all lamps in the output: The average brightness of all DALI lighting
groups is sent as the status of the DALI output on the KNX.
highest brightness of all lamps in the output: The highest brightness value of the DALI devices
is taken as the status of the DALI output sent on the KNX.
lowest brightness of all lamps on the output: The lowest brightness value of the DALI devices is
taken as the status of the DALI output sent on the KNX.
Using the following parameters, further communication objects and their associated functions for
the output of the DGN/S can be enabled.
DGN/S 1.16.1 | 2CDC 507 114 D0201 45