ABB i-bus KNX Product Manual page 36

®
ABB i-bus KNX
Commissioning
Allow switching ON channel
via dim telegram
Options:
Using this parameter, the switch on behaviour of the entire DALI output is parameterized during dimming
with the central telegram.
yes: Switch on using the DIM telegram is allowed.
no: Switch on using the DIM telegram is not allowed. The DALI output must be switched on in order to
be dimmed.
Allow switching ON via brightness value
Options:
Using this parameter, the switch on behaviour of the DALI output with a received brightness value (com-
munication object DALI output: Brightness value) is set.
yes: Switch on with a brightness value (8 bit > 0) is permitted.
no: Switch on with a brightness value is not permitted. The DALI output must be switched on in order
to execute the brightness value telegram.
Allow switching OFF via brightness value
Options:
Using this parameter, the switch off behaviour of the DALI output is set with a received brightness value.
yes: Switch off with a brightness value is permitted.
no: Switch off with a brightness value is not permitted. The DALI output must be implemented with an
OFF telegram via the communication objects Switch or Switch/status.
Dim period to reach turn on or off
brightness (Fct "Switch") in s
Options:
A soft start or soft stop can be set with this parameter. For this purpose, the period is defined, in which the
DGN/S using an ON telegram dims the lighting group from 0 % brightness to the switch on value after re-
ceipt of a switch telegram on one of the central communication objects of the DALI output, Switch or
Switch/status. The same speed also applies for an OFF telegram. The dim period is only relevant for cen-
tral ON/OFF telegrams (1 bit).
jump to: All devices on the DALI output immediately switch ON.
0.7 s...90 s: During this time, the lighting group is dimmed from 0 % brightness to the switch on value.
34 2CDC 507 114 D0201 | DGN/S 1.16.1
yes
no
yes
no
yes
no
jump to
0.7 s
2 s
...
90 s