Table of Contents
Advertisement
ICP DAS PMC/PMD Series User Manual
7.1.3
Add Modbus TCP Power Meter Manually
PMC/PMD allows connection to Modbus TCP Power Meters via
Ethernet, the user could add the Modbus TCP Power meter to the list
manually; the steps are as below:
i No: The Number will be the order that the power data of the
Modbus TCP power meter being stored in the PMC/PMD Modbus
Table. The range is 1~16.
ii Network: Set up the settings of IP, Port and NetID appropriately as
required. Please make sure the network setting is the same as the
settings of the module, if the setting is not accurate, the connection
for PMC/PMD to the power meter will be failed.
iii Select the Power meter model (Figure 7-12):
Figure7-10 :
Add the Modbus RTU Power Meter manually
Figure7-11 :
Add Modbus TCP Power Meter
83
Advertisement
Table of Contents
