Table of Contents
Advertisement
ICP DAS PMC/PMD Series User Manual
The settings steps are as below:
i Select the number of the Internal Register from the dropdown list, input
"Name" and "Initial Value" and then click
Register.
Please Note: there are up to 48/70 Internal Register can be enabled, if
the name of the register is not inputted, the name will be automatically
set as "Internal Register#"(#is the number of the register), the default
initial value will be set as 0.
ii
To modify the settings of a pre-set internal register, please click on the
radio button in front of the register, and then click on "Setting" to
modify the settings.
iii To copy the settings of a pre-set internal register to the new internal
register, please click the radio button in front of the pre-set internal
register and then click "Copy", a new internal register(in sequence)
will be added to the list and the settings of the old internal register will
be copied to this newly added internal register.
iv To remove a pre-set internal register, please click the radio button in
Figure10-37 : Internal Register setting page(1)
Figure10-38 : Internal Register setting page(2)
to add new Internal
181
Advertisement
Table of Contents
