Table of Contents
Advertisement
ICP DAS PMC/PMD Series User Manual
v After the Scan operation is completed, a Power Meter List will
appear (Figure 7-6). If the newly scanted module doesn't match the
module previously set on the same address, a window will appear
(Figure 7-7), please select the actual device that are connected to
PMC/PMD. After all settings are completed, click "Save" button to
save the changes.
7.1.2
Add Modbus RTU Power Meter Manually
In addition to perform Scan operation to automatically add Modbus
RTU power meters to the list, the user could also add the Modbus RTU
power meter manually one by one, the steps are as below:
Figure7-5 :
Figure7-6 :
The Power Meter List after Scan operation
Figure7-7 :
Select the actual Power Meter connected to PMC/PMD
Scanning the Power Meters
81
Advertisement
Table of Contents
