Scan To Add Icp Das M-7000/Dl Modules; Figure7-27 : The "Scan" Button To Search M-7000/Dl Module; Figure7-28 : Set Up The Scanning Range For The M-7000/Dl Module - ICP DAS USA PMC series User Manual

ICP DAS PMC/PMD Series User Manual
7.3.1

Scan to Add ICP DAS M-7000/DL Modules

The user could use Scan function to add ICP DAS M-7000/DL
Modules to the PMC/PMD, the steps are as below:
i Click on
connected to the PMC/PMD.
ii When the Scan page appears (Figure 7-28), input the starting
address and the ending address of the Modbus address that are going
to perform scan. Click on "Scan", the system will start to scan the
M-7000/DL modules that match the settings previously set, to
cancel the scan, click on "Cancel".
iii When the system is performing the scan (Figure 7-29), the address
that are performing scan will be dynamically shown on the upper
left side, please wait till the scan operation is completed. To stop the
scan operation, click on "Cancel" to terminal the scan and leave the
page.
button to scan the M-7000/DL modules that are
The "Scan" button to search M-7000/DL module
Figure7-27 :
Figure7-28 : Set up the Scanning Range for the M-7000/DL module
98