If Condition Setting - ICP DAS USA PMC series User Manual

ICP DAS PMC/PMD Series User Manual
 Setting: to edit a pre-set function component, click on
page of the function component.
 Copy: to copy a pre-set function component, click on
component with the same pre-set component settings. The new function
component will be listed under the pre-set component.
 Remove: to remove a pre-set function component, click on
component.
 Arrange order: the order of the function component might result in different
outcomes of IF-THEN- ELSE rule execution, therefore, user could click
on and drag the component to arrange the components into appropriate order.
The following section will give more detailed information of IF Condition and
THEN/ELSE Action settings.

11.1 IF Condition Setting

To add an IF Condition, please select and set the Condition from the
dropdown list in the "Add a new Condition" field under the IF Condition
setting section.
IF Condition provides the following Condition setting options:
 ICP DAS Module
 Modbus Module
 Power Meter
 Microsoft Azure
 IBM Bluemix
 MQTT
 Connection Status
 Timer
 Schedule
 Mobile Network Signal Strength
 FTP Upload Status
 SD Card Status
 Rule Status
 Internal Register
If the PMC/PMD is connected to ICP DAS XW-Board/XV-Board/M-7000/
DL I/O modules, ICP DAS power meters or Modbus TCP/RTU modules,
the setting options for I/O channel information (AI, DI, Discrete Input, Coil
to get in to the setting
to generate a new
to remove the
185