Figure11-28 : Coil Output Action Setting Page; Figure11-29 : Holding Register Action Setting Page - ICP DAS USA PMC series User Manual

ICP DAS PMC/PMD Series User Manual
Follow the steps below:
i
ii Specify the output value of Coil Output from the dropdown list
iii Specify the "Frequency" to be "One-Time" or "Repeat".
iv Click "OK" button to confirm the settings and return to the
11.2.2.2 Holding Register
You can execute an action to change the value of Holding Register
in the THEN/ELSE Action statement; the editing page for Holding
Register Action is shown as follow:
Follow the steps below:
i
ii Specify the Operator in the "Operator" field. The 3 operators

Figure11-28 : Coil Output action setting page

Select the module and address of the Coil Output from the
dropdown list of the "Module & Address" section.
of the "Status" field. The output value can be "OFF" or, "ON".
Rule settings page.

Figure11-29 : Holding Register action setting page

Select the module and address of the Holding Register from
the dropdown list of the "Module & Address" section.
are as follow：
 "="：Indicate assign the new Holding Register value as the
value in "Value" field.
 "+="：Indicate assign the new Holding Register value as
the original Holding Register value plus the value in
"Value" field.
208