Factory Default Settings; Transmitter; Receiver - Lightware HDMI-3D-OPT-TX210A User Manual


  
11. Appendix
11.3. Factory Default Settings
11.3.1. Transmitter
Parameter
Video
Audio
Video input port settings (DP*, HDMI, DVI-D*)
HDCP
Video output port settings (optical link and local HDMI)
HDCP mode
Autoselect *
Autoselect mode *
Autoselect video priority *
Test pattern mode
Test pattern resolution
Test pattern
Signal type
HDCP mode
Laser enable
Analog audio input port properties
Volume
Balance
Gain
Audio output port settings (optical link and local HDMI)
Autoselect *
Autoselect mode *
Autoselect video priority *
IP address
Subnet mask
Static gateway
DHCP
LW2 / LW3 port number
Setting/Value
Crosspoint settings *
I1 (DisplayPort)
I1 (DisplayPort)
Enabled
Enabled
Disabled
Priority detect
0=DP, 1=HDMI, 2=HDMI2, 3=DVI-D
Off
480p
Bar
Auto
Auto
On
0.00 dB
0 (center)
0.00 dB
Disabled
Priority detect
0=DP, 1=HDMI, 2=HDMI2, 3=DVI-D, 4=Analog 1 (Jack),
5=Analog 2 (Phoenix)
Network settings *
192.168.0.100
255.255.255.0
192.168.0.1
Disabled
10001
HDMI-3D-OPT series – User's Manual
Parameter
Control protocol
Baud rate / Databits / Parity / Stopbits
Operation mode
Command injection port nr.
Direction
Output level
* Only for SW4-OPT-TX240RAK model.
11.3.2. Receiver
Parameter
HDCP
Signal type
HDCP mode
Power 5V mode
Test pattern mode
Test pattern resolution
Test pattern
Volume
Balance
Bass
Treble
Phase invert
Control protocol
Baud rate / Databits / Parity / Stopbits
Operation mode
For the procedure of reloading factory default values in LDC software see the
function buttons see in the

Factory Default Settings

section for the receiver.
Setting/Value
RS-232 settings
LW2
57600 / 8 / No / 1
Pass-through
8001
GPIO port settings *
Input
High
Setting/Value
Optical input port properties
Enabled
HDMI output port properties
Auto
Auto
Always on
Off
480p
Bar
Analog audio output port properties
0.00 dB (100%)
0 (center)
0.00 dB
0.00 dB
Disabled
RS-232 settings
LW2
57600 / 8 / No / 1
Pass-through
Reset to Factory Default Settings section for the transmitter and the
92
System section, or using the
Reset to