System Commands; Query The Product Name; Set The Device Label; Query The Serial Number - Lightware HDMI-3D-OPT-TX210A User Manual


  
7. LW3 Programmer's Reference
7.5. System Commands
7.5.1. Query the Product Name
The name of the product is a read-only parameter and cannot be modified.
Command format: GET●/.ProductName
Response format: pr●/.ProductName=<Product_name>
Example:
˃ GET /.ProductName
˂ pr /.ProductName=SW4-OPT-TX240RAK
7.5.2. Set the Device Label
ATTENTION! The device label can be changed to a custom text in the
writable parameter is not the same as the ProductName parameter.
Command format: SET●/MANAGEMENT/UID/DeviceLabel=<Custom_name>
Response format: pw●/MANAGEMENT/UID/DeviceLabel=<Custom_name>
The Device Label can be 39 character length and ASCII characters are allowed. Longer names are truncated.
Example:
˃ SET /MANAGEMENT/UID.DeviceLabel=SW4-OPT_Control_room
˂ pw /MANAGEMENT/UID.DeviceLabel=SW4-OPT_Control_room
7.5.3. Query the Serial Number
Command format: GET●/.SerialNumber
Response format: pr●/.SerialNumber=<serial_nr>
Example:
˃ GET /.SerialNumber
˂ pr /.SerialNumber=87654321
7.5.4. Query the Firmware Version
Command format: GET●/SYS/MB.FirmwareVersion
Response format: pr●/SYS/MB.FirmwareVersion=<firmware_version>
˃ GET /SYS/MB.FirmwareVersion
˂ pr /SYS/MB.FirmwareVersion=1.1.0b5 r8
HDMI-3D-OPT series – User's Manual
Status tab of the LDC software. This
7.5.5. Resetting the Device
The transmitter can be restarted – the current connections (LAN, RS-232) will be terminated.
Command format: CALL●/SYS:reset()
Response format: mO●/SYS:reset=
Example:
˃ CALL /SYS:reset()
˂ mO /SYS:reset=
7.5.6. Restore the Factory Default Settings
Command format: CALL●/SYS:factoryDefaults()
Response format: mO●/SYS:factoryDefaults=
Example:
˃ CALL /SYS:factoryDefaults()
˂ mO /SYS:factoryDefaults=
The device is restarted, current connections are terminated, and the default settings are restored. See the
complete list in the Factory Default Settings section.
57