3.6
Timeout Settings
A timeout may occur when processing various requests from Device DTM to M_CommDTM-HART takes time. The
processing time increases especially when the HART communication function is used on multiple channels.
When a timeout occurs, change the time until the timeout occurs according to the following procedures.
1.
Right-click on "M_CommDTM-HART" of MyNetwork to select "Timeout settings".
[MyNetwork] [M_CommDTM-HART] Right-click [Configuration] [Timeout settings]
2.
Set "Request timeout" in the "Timeout settings" window.
Timeout settings item
Request timeout
3.
Click [OK].
Description
This item is used to set the time until the timeout is judged.
■Setting range
5 to 1800 (seconds)
3 CommDTM
71
3.6 Timeout Settings
3