Mitsubishi Electric Melsec iQ-R Series User Manual page 124

CH1 Range setting
This area is for setting an input range.
Setting value
0H
1H
AH
• If a value other than the above is set, a range setting range error (error code: 190H) occurs.
• The input range cannot be switched for the channel where A/D conversion disable is set. To switch the input range, set
'CH1 A/D conversion enable/disable setting' (Un\G500) to A/D conversion enable (0) and turn on and off 'Operating
condition setting request' (Y9).
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Range setting
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is 4 to 20mA (0H) for all channels.
APPX
122
Appendix 3 Buffer Memory Areas
Setting details
4 to 20mA
0 to 20mA
4 to 20mA (extended mode)
CH1 CH2 CH3
598 798 998
CH4 CH5 CH6
1198 1398 1598
CH7 CH8
1798 1998