Connection Settings Of Another Station A/D Converter Module - Mitsubishi Electric Melsec iQ-R Series User Manual

Connection settings of another station A/D converter module

This section describes the connection settings of another station A/D converter module.
1.
Configure the settings according to the used programmable controller system by referring to steps 1 to 7 of Page 62
Connection settings of host station A/D converter module.
2.
Set a network route in the "Transfer Setup Wizard - Network" window.
Network item
Station type
PLC mode
Network
3.
Set "Network route" when "Network" is set to "C24" or "CC-Link".
Network item
Network type
I/O address
Description
This item is used to select where to mount the A/D converter module. Select "Other station" in this step.
■Setting range
• Host station
• Other station
This item use used to select a CPU module series when the CPU module is set to be connected from the Ethernet
board.
■Setting range
• QCPU
• RCPU
• LCPU
This item is used to select a network route to another station.
■Setting range
• CC IE Control
• CC IE Field
• Ethernet
• C24
• CC-Link
Description
Automatically sets the setting made in "Network" in step 2.
This item is used to set I/O address of the RJ71C24 or RJ61BT11 of the target station.
■Setting range
0000H to FFF0H
3 CommDTM
67
3.4 Connection Settings
3