Mitsubishi Electric Melsec iQ-R Series User Manual page 116

• Set a primary delay filter constant for the primary delay filter. The value of the time constant (ms) is the
product of the primary delay filter constant and the sampling cycle.
• Since the default value is 0, change the value depending on the processing.
• When Sampling processing (0) is set in 'CH1 Averaging process specification' (Un\G501), the setting of this
area is ignored.
CH1 Scaling enable/disable setting
Set whether to enable or disable the scaling.
For details on the scaling function, refer to the following.
Page 29 Scaling Function
Setting value
0
1
If a value other than the above is set, a scaling enable/disable setting range error (error code: 1A0H) occurs.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Scaling enable/disable setting
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is Disable (1) for all channels.
CH1 Scaling upper limit value
Set an upper limit value for the range of the scale conversion.
For details on the scaling function, refer to the following.
Page 29 Scaling Function
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Scaling upper limit value
■Setting range
• The setting range is from -32000 to 32000.
• In the channel where a set value does not satisfy the condition "the scaling upper limit value  the scaling lower limit value",
a scaling upper/lower limit value setting error (error code: 1A2H) occurs.
• In the channel where a value out of the setting range is set, a scaling setting range error (error code: 1A1H) occurs.
• When 'CH1 Scaling enable/disable setting' (Un\G504) is set to Disable (1), the setting of 'CH1 Scaling upper limit value'
(Un\G506) is ignored.
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is 0 for all channels.
APPX
114
Appendix 3 Buffer Memory Areas
Setting details
Enable
Disable
CH1 CH2 CH3
504 704 904
CH1 CH2 CH3
506 706 906
CH4 CH5 CH6
1104 1304 1504
CH4 CH5 CH6
1106 1306 1506
CH7 CH8
1704 1904
CH7 CH8
1706 1906