Table of Contents
Advertisement
2.
Note: Be sure to issue a break sequence before the boot process completes.
Break sequences can vary, depending on the console equipment type. Some
console terminals have specific break keys on their keyboards; other
management terminals require a specific key sequence to issue a break (for
example,
documentation for the break sequence specific to your console equipment.
Logging in to the Command Line Software
Regardless of the command line software used -- ARN monitor or Technician
Interface -- the procedures are identical from the login prompt.
To log in to the command line:
1.
2.
114200 Rev. A
While the router is running the EZ-Install procedure, issue a break
sequence from the management console.
The ARN monitor login prompt appears.
or
). Refer to your console terminal or terminal emulator
Cntrl-C
~ #
Type the following command at the login prompt and press the Return
key:
Manager
Note the use of an uppercase "M."
The Technician Interface or ARN monitor command line prompt appears. You
are now using a command line interface to the router.
To use the netboot, directed netboot, or the local boot option, go to one of
the following sections that describes the procedure you want to use:
•
Continuing with Netboot
•
Continuing with Directed Netboot
•
Continuing with Local Boot
Starting the ARN
2-7
Advertisement
Table of Contents
Need help?
Do you have a question about the BayStack ARN Routers none and is the answer not in the manual?
Questions and answers