Understanding Quick-Start Connector Names And Numbers - Bay Networks BayStack ARN Routers none Installation And Operating Manual

Installing and Operating BayStack ARN Routers

Understanding Quick-Start Connector Names and Numbers

The Quick-Start script assigns a name and number to each interface, depending on
its location on the ARN.
In addition to either an Ethernet or token ring base module, the ARN can contain
expansion modules and adapter modules
U
D B1
1
ISDN BRI
DD B2
withNT1
COM
2
RLSD
Serial
Figure B-1. ARN Module Locations
Table B-1
Quick-Start procedure.
Table B-1.
Interface*
Ethernet
Token Ring
Serial
56/64K DSU/CSU
*. The Quick-Start script does not support initial ISDN or V.34 interface configuration.
B-2
Adapter modules
UTP
RCVR
STP
NSRT
WFLT
Token Ring 2
10BaseT
Tx
AUI
Rx
Cl
Ethernet 1
provides the connector names and numbers you should use during the
Quick-Start Connector Names and Numbers
Module
Base
XCVR1
MAU1
N/A
N/A
(Figure B-1).
Expansion module
RLSD3 COM3
RLSD4
RLSD5
Run Pwr Base Expansion
Boot RPS Adapter1 DCM
Fail Fan Adapter2 PCMCIA
Base module
Expansion Adapter 1
XCVR2 N/A
MAU2 N/A
COM3, COM4, COM1
or COM5
N/A COM1
COM4 COM5
Serial
BayStack Advanced Remote Node
ARN0006A
Adapter 2
N/A
N/A
COM2
COM2
114200 Rev. A