Using Ez-Install - Bay Networks BayStack ARN Routers none Installation And Operating Manual

Using EZ-Install

EZ-Install is the default installation option. This option requires that your network
administrator has set up the network so that you can start the EZ-Install procedure.
In addition, this option requires that you
•
•
Refer to Chapter 1 for instructions on how to perform any of these tasks.
Note: If your ARN does not have a COM interface, you must configure the
ARN using netboot or directed netboot over an Ethernet, token ring, or
DSU/CSU interface, or local boot the ARN and run the Quick-Start script. Go
to the next section, "Using Netboot, Directed Netboot, or Local Boot," for
more information.
To use EZ-Install:
1.
Note: If you power on the ARN before the network administrator is ready,
restart the ARN by pressing the reset button on the rear panel. See Chapter 3
for more information on resetting the ARN.
2.
114200 Rev. A
Install a Flash memory card.
Connect at least one serial (COM) interface to the network.
Press the power switch on the ARN back panel to the ON position.
The ARN comes on and activates EZ-Install.
Ensure that the ARN boots correctly.
When the ARN boots, its LEDs flash in a particular order. See Chapter 3 for
information on checking the ARN front-panel LEDs to ensure that the
installation was successful and that the router is operating properly.
Starting the ARN
2-5