Table of Contents
Advertisement
General Information
Printing Copies from Keysight
1
General Information
Printing Copies from Keysight
Product maintenance agreements and other customer assistance agreements
are available for Keysight products.
For any assistance, contact Keysight Technologies. Refer to
Keysight" on page 6-3
Calibration Kit Overview
This waveguide calibration kit is used to calibrate network analyzer systems
(such as the Keysight 8510, 872x, or PNA series). With the calibration data
properly loaded in the network analyzer and a measurement calibration
completed, systematic errors are minimized.
TRL (thru-reflect-line) calibrations require Keysight 8510 operating system
firmware revision B.05.12 or greater.
Kit Contents
Use the Contents List in the shipping container to verify the completeness of
your shipment. Although this list is the most accurate, you can also use the
illustrations in Chapter 7 to verify the items in your shipment. If your shipment
is not complete, contact Keysight Technologies - refer
on page
The standards in this calibration kit allow you to perform simple 1- or 2-Port
and TRM (thru-reflect-match) calibrations.
For your convenience, two different lengths of screws are provided in this kit.
While you can use the long screws for any connection, the shorter screws
provide a faster connection for two-flange connections.
Calibration Definitions
The calibration kit must be selected and the calibration definitions for the
devices in the kit installed in the network analyzer prior to performing a
calibration.
The calibration definitions can be:
— resident within the analyzer
— manually entered from the front panel
Keysight R, Q, U, V, and W11644A
for a list of Keysight contacts.
6-3.
"Contacting
to"Contacting Keysight"
1-1
Advertisement
Table of Contents
