Controls And Displays; Function Keys On The Left; Function Keys In The Center; Clear/Restore - Hofmann geodyna 2600 Operation Manual

1
2
8
1
9
4 5
10
4
3
2 3
6 7

4. Controls and displays

Fig. 8 Overview
1 START key Start a
measuring run
2 STOP key
- Interrupt the measuring run
- Delete an error code
- If input of a mode of operation is completed with
the STOP key, the new state is deselected
and the former state is re-established. 3 Function keys
(see Fig. 9 to 11)
4 Display (see Fig. 12 to 15)
Fig. 9 Function keys on the left
1 Function key for distance rim / machine
2 Function key for rim width
3 Function key for rim diameter
Fig. 10 Function keys in the center
4 PRO MATCH
- Starts an optimisation program (LED PRO MATCH
lights).
- In the Pro-Match program (OP program): enter valve
position.

5 CLEAR/RESTORE

CLEAR (key pressed briefly): Setting the factory adjusted
modes of operation. All settings are deleted and the
display returns to standard.
RESTORE (key pressed for 3 seconds): Restores all
modes the way they were before clear was pressed.
6 CALIBRATE/CODE
CALIBRATE (key pressed briefly): Sets the machine in
the user calibration mode (see § 13. User calibration).
(key pressed for 3 seconds): Switches to changing
modes of operation.
7 G/OZ
Switches over the weight unit for unbalance readings
(grammes or ounces).
G Readings in grammes Oz
Readings in ounces
When the machine is switched on the weight unit set with
code C3 is active.
Operation manual geodyna 2600 EEWB703D
Controls and displays
automatically
CODE
7