How To Continue The Pro-Match Program; To Continue Pro-Match; To Abort Pro-Match - Hofmann geodyna 2600 Operation Manual

Pro-Match/Weight minimisation
113
114
115
48
START

How to continue the Pro-Match program

• Press the START key (Fig. 112) to start the compensa-
tion run of rim without tire.
After the measuring run the reading is OP.3 (Fig. 113).
• Mount the tire and inflate.
Note
For mounting, demounting, readjustment or turning over of
the tire on the rim always apply a sufficient quantity of tire
lubricant on tire beads, rim flanges and bead seats. Each time
the tire has been readjusted relative to the rim, inflate tire ac-
cording to the tire manufactures recommendation. Make sure
the mounting guide rib of the tire is correctly seated.
• Clamp the tire/rim assembly on the balancer.
• Readjust such that the valve is set at 12:00 o'clock.
• Press the PRO MATCH key to enter the valve position.
Reading OP.4 (Fig. 114) comes up).
• Press the START key.
The measuring run is carried out. After the measuring run two
readings are possible:
OP.5 - H 1 (see Fig. 115)
Further Pro-Match is not recommended, but possible.
OP.5 - reference mark (see Fig. 116)
Continue with the Pro-Match program.
Reading OP.5 - H 1 (Fig. 115)
If OP.5 - H 1 is read out further Pro-Match is not recommend-
ed. In this case the measured data does not exceed the limit
for recommendation of the Pro-Match program. However, it is
possible to continue Pro-Match so as to improve wheel run-
ning conditions even below the limit value.

To continue Pro-Match:

• Proceed as specified for reading OP.5 - reference mark
(see Fig. 115).

To abort Pro-Match:

• Press the STOP key to return to the balancing program
and balance the wheel according to the readings.
Operation manual geodyna 2600 EEWB703D