Balancing The Wheel; Measurement - Hofmann geodyna 2600 Operation Manual

ALU
45
ALU
46
1
2
47
inch mm
START
25
48

8. Balancing the wheel

Preparations:
- Compensation run carried out, if necessary (see § NO
- Wheel correctly clamped (see § 6.3).
- Balancing mode chosen (see § 7.1).
- Distance and rim dimensions entered (see § 7.2).
If several wheels with identical nominal rim dimensions are
balanced in succession, it is only necessary to enter the data
for the first wheel. The inputs will remain stored until new data
is entered.

8.1 Measurement

On reaching the respective correction position only the two
arrow-heads are visible (Fig. 48, item 2).
For correct fitting of the balance weights see Fig. 49, 51
2
1
and 54.
2
Fig. 48 Example of display and correction of the righthand
1 Display of amount of unbalance
2 Display of correction position - only the arrow-heads light up
3 Position of balance weight on rim
1
3
Operation manual geodyna 2600 EEWB703D
TAG).
• Start the measuring run.
• Index the wheel into correction position following the
direction indicated (Fig. 47, item 1).
• In this position attach a balance weight in the correc-
tion position at the top of the rim, at 12:00 o'clock (Fig.
48, item 3).
correction plane
Balancing the wheel
27