Minimisation Program; To Continue With The Minimisation Program; To Abort Minimisation - Hofmann geodyna 2600 Operation Manual

122
START
123
124
Pro-Match/Weight minimisation

12.4 Minimisation program

If the compensation run of the rim without tire was omitted and
the FINE key was pressed to go directly into the minimisation
program (reading Un.3 - Fig. 122), proceed as follows.
• Clamp the tire/rim assembly on the balancer.
• Readjust such that the valve is at 12:00 o'clock.
• Press the PRO MATCH key to enter the valve position.
Reading Un.4 comes up (Fig. 123).
• Press the START key.
The measuring run is carried out. After the measuring run two
readings are possible:
Un.5 - H 1 (see Fig. 124)
Further minimisation is not recommended, but possible.
Un.5 - reference mark (see Fig. 125)
Continue with the Un program.
Reading Un.5 - H 1 (Fig. 124)
If Un.5 - H 1 is read out further minimisation is not recommen-
ded. In this case, the measured data does not exceed one
ounce. However, it is possible to continue minimisation to
achieve an improvement, if only slight.

To continue with the minimisation program:

• Proceed as specified for reading Un.5 - reference mark
(see next page).

To abort minimisation:

• Press the STOP key to return to the balancing program
and balance the wheel according to the readings.
Operation manual geodyna 2600 EEWB703D
53