Reading Un.5 - Reference Mark - Hofmann geodyna 2600 Operation Manual

Pro-Match/Weight minimisation
125
126
54
START
Reading Un.5 - reference mark (Fig. 125)
• After the measuring run index the wheel following the
position reading and provide a crayon mark on the right
side of the tire at 12:00 o'clock.
• Readjust the tire on the rim such that the tire mark coin-
cides with the valve.
• Clamp the tire/rim assembly on the balancer and read-
just such that the valve is at 12:00 o'clock.
• Press the PRO MATCH key to enter the valve position.
Reading Un.6 (Fig. 126) comes up.
• Press the START key.
The second measuring run of the tire/rim assembly is started.
After the measuring run three readings are possible:
=== - Un.7 (see Fig. 127)
Proceed with the Un program. It is recommended that the tire
be turned over on the rim.
Un.7 - === (see Fig. 128)
Proceed with the Un program. It is recommended that the tire
be adjusted on the rim.
H 0 (see Fig. 129)
Optimum condition has been achieved and cannot be
improved.
Depending on the readings, there are several possibilities
for proceeding with the program. These possibilities are
described below.
Operation manual geodyna 2600 EEWB703D